split ratio
英 [splɪt ˈreɪʃiəʊ]
美 [splɪt ˈreɪʃioʊ]
网络 分流比; 拆分比例; 分路比; 分光比; 分割率
双语例句
- The experimental results show that the split ratio and feed rate are two important operational parameters for the pulp fiber fractionation with cylindrical hydrocyclone.
有实验研究表明，分流比和进料量是影响低浓度纸浆纤维在长柱形水力旋流器内筛分效果的重要操作参数。 - The experiment shows that no stubble scorching happens and that the split ratio of the remaining stubbles of Caragana microphylla is very low, which has no effect on the germination of shrubs.
试验表明，灌木柠条留茬的劈裂率很小，并且没有留茬烧焦现象，出现的少数劈裂对灌木的萌发也未产生影响。 - The flow rate, electromechanical rotation rate and split ratio are the main operational parameters which can affect the separation characteristics of the compound hydrocyclone.
流量、电动机转速及分流比是影响复合式水力旋流器分离特性的主要操作参数。 - Important parameters identified include column temperature, carrier gas flow-rate, injection temperature, split ratio and sample size.
该文章讨论了一些包括柱温、载气流速、进样温度、分流比和进样量等重要因素。 - Evaluation of asphalt mixture for resistance to water damage based on freeze-thaw cycle split ratio
用冻融循环劈裂比评价沥青混合料抗水损害能力 - The main operating parameters influencing the separating effect are inlet flow and split ratio.
影响旋流器分离性能的操作参数主要是进口流量和分流比。流量和分流比与进口压力、底流口压力和溢流口压力间存在函数关系。 - Split stream sampling was applied, split ratio was 20 ∶ 1;
分流进样，分流比20∶1； - By regulating the differential pressure between the inlet and bottom outlet or between the inlet and overflow, the inlet flow and split ratio can be controlled.
通过调节进口到底流口的压差和进口到溢流口的压差，可以控制旋流器的进口流量和分流比。预分水旋流器存在一个最佳分流比，与此相应的溢流含水量最小。 - The pressure drop ratio would decrease with the increases of flow rate, split ratio, swirl number.
随着溢流口直径的加大，水力旋流器的溢流压力降减小，而压降比也随之降低； - The split ratio had little influence on the mean droplet sizes at the wall of hydrocyclone.
分流比对旋流器各段边壁的油滴粒径影响不大。 - 30/ 1 of split ratio.
分流比：30/1。 - The effects of feed rate and split ratio ( overflow rate to feed rate ratio) on fractionation of pulp fiber are studied.
研究了进料量Qf和分流比R（溢流与进料之比）对筛分的影响。 - Relationships of inlet flowrate with pressure drop and with pressure drop ratio, split ratio with separation efficiency, motor speed with pressure drop and with separation efficiency and so forth are ascertained by experiments.
试验确定了复合式水力旋流器入口流量与压力损失、入口流量与压降比的关系以及分流比对分离效率的影响和电机转速对压力损失、分离效率的影响关系。 - Reasonable operating parameters, such as flow rate, flow split ratio and pressure drop, are worked out, and the field technological process of the hydrocyclone is investigated tentatively.
摸索出了较为合理的操作参数（处理量、分流比及压力降等），并对预分离水力旋流器的现场应用工艺流程进行了初步探讨。 - And the effect of flow rate Qi and split ratio F on pressure drop was analyzed in order that the reasonable operation parameters were determined.
在实验的基础上，通过对实验数据的整理，结合理论分析，确定合理的结构方案，同时分析了流量Qi、分流比F对压力降Δp的影响，确定合理的操作参数。 - Study of the Split ratio Characteristic coefficient of Hydrocyclone for Liquid-liquid Separation
液-液旋流器分流比特性系数研究 - Some factors 'influence on the extinction ratio were analyzed, such as signal power, control power, fiber length and coupler's split ratio.
介绍了其工作原理，详细分析了信号光强度、控制光强度、光纤长度及耦合器分光比偏差等因素对各端口消光比的影响。 - The relationship between pressure-drop ratio and flow rate, split ratio, overflow outlet diameter, bigger cone, and smaller cone in the liquid-liquid hydrocyclone separation are discussed in the paper.
分析了入口总流量、分流比、溢流口直径与液-液水力旋流器压降比的关系，讨论了大、小锥角及入口尺寸比变化对压降比的影响。 - The effects of insertion loss, split ratio, polarization crosstalk and back reflection of Y-type integrated optic circuits are analyzed.
分析了Y型集成光路器件的插入损耗、分光比、偏振串音和背向反射等主要技术指标对陀螺性能的影响。 - The effects of operating parameters such as split ratio and feed flowrate on separation efficiency were analyzed.
并考察了油滴直径、进料流量及溢流比的变化对分离效率的影响。 - The air with 800-1300 can be generated efficiently and stably by optimizing fuel/ air ratio and split ratio.
优化燃空比和分流比，可高效稳定地生成800-1300℃高温空气； - The influence of inside and outside the air gap combination, split ratio and relative position of the inside and outside stator on motor performance was also analyzed, and the method to determine the optimal design of electrical machine is given.
并对电机内、外气隙配合，电机裂比和内、外定子相对位置对电机性能的影响进行研究，给出确定电机最优设计方案的方法。 - With the influent split ratio increased, the TN removal rate also increased, up to 92.6%.
随着进水分流比的增加，系统所能达到的总氮去除率也随之增加，最高可达92.6%。 - Therefore, the application of higher influent split ratio helped to improve the denitrification efficiency.
因此采用较高的进水分流比利于提高系统的脱氮效能。 - The underflow tube has an important effect on split ratio and cut diameter, which is one of the important factors to the separation performance of the hydrocyclone.
旋流器底流管对水力旋流器的分流比大小、分割粒径的大小等都有较大的影响，是影响旋流器分离性能的重要因素之一。 - The optimal GC split ratio is60:1.3.
最佳气相色谱分流比为60：1。 - Under different influent split ratio, ammonia nitrogen removal rate could reach to 93.4% or more.
不同进水分流比条件下，系统对于氨氮的去除率均达到93.4%以上。 - Based on the principle of optimal efficiency, the best split ratio of the motor was analyzed.
基于效率最优的原则，对电机最佳裂比进行了分析，同时还对转子长径比进行了优化分析。 - A lot of experiments are conducted, the properties of two hydrocyclones are studied, split ratio, gas-liquid volume ratio, overflow outlet size, inlet liquid flow and other parameters are further determined.
对实验样机进行了大量的实验，研究两种旋流器的各项性能，进一步确定分流比、气液体积比、溢流口尺寸及入口液体流量等参数。 - By the experimental study on the new structural gas-liquid separators, tested its best working conditions, the effects of flow rate, split ratio and pressure on the separation efficiency was researched.
通过对新型气-液旋流分离器进行实验研究，测定出样机的最佳工作状况，研究了流量、分流比、压力对分离效率的影响，同时验证了数值模拟结论的合理性。